electro-music.com   Dedicated to experimental electro-acoustic
and electronic music
 
    Front Page  |  Radio
 |  Media  |  Forum  |  Wiki  |  Links
Forum with support of Syndicator RSS
 FAQFAQ   CalendarCalendar   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   LinksLinks
 RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in  Chat RoomChat Room 
 Forum index » DIY Hardware and Software » Ken Stone designs - CGS
CGS77 input bleed
Post new topic   Reply to topic Moderators: Scott Stites
Page 1 of 1 [3 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
Author Message
whomper



Joined: Dec 15, 2007
Posts: 201
Location: Israel
Audio files: 2

PostPosted: Fri Jul 23, 2010 12:05 pm    Post subject: CGS77 input bleed Reply with quote  Mark this post and the followings unread

Hi,

Testing my newly built CGS77 serge filter provided two challenges to solve:

1. I get an input bleed to all outputs. It is present even at power off and is also present on the power rail (+, - and gnd).
2. The BP is very low in level compared to the LP and HP.

Am not using the on board buffers.

Any ideas?

_________________
Erez Yaary

Home Page: http://www.yaary.com
Buy my CDs at http://www.mellowjet.de
Back to top
View user's profile Send private message
andrewF



Joined: Dec 29, 2006
Posts: 1176
Location: australia
Audio files: 4

PostPosted: Fri Jul 23, 2010 9:18 pm    Post subject: Reply with quote  Mark this post and the followings unread

These are just suggestions scratch :
outside of solder bridges and wiring errors
the bleed thru can be caused by a problem with your power supply, it can happen when the power supply is overworked.
also it could (possibly?) be caused by one or boh of the fets installed incorrectly.
Back to top
View user's profile Send private message Visit poster's website
whomper



Joined: Dec 15, 2007
Posts: 201
Location: Israel
Audio files: 2

PostPosted: Sat Jul 24, 2010 4:07 am    Post subject: Reply with quote  Mark this post and the followings unread

Removed all trannys, wires etc just to find out I forgot to ground the panel to the board Embarassed .....

No issue, board is working great!

_________________
Erez Yaary

Home Page: http://www.yaary.com
Buy my CDs at http://www.mellowjet.de
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic Moderators: Scott Stites
Page 1 of 1 [3 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
 Forum index » DIY Hardware and Software » Ken Stone designs - CGS
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Forum with support of Syndicator RSS
Powered by phpBB © 2001, 2005 phpBB Group
Copyright © 2003 through 2009 by electro-music.com - Conditions Of Use