electro-music.com   Dedicated to experimental electro-acoustic
and electronic music 		 
    Front Page  |  Radio
 |  Media  |  Forum  |  Wiki  |  Links
Forum with support of Syndicator RSS
 FAQFAQ   CalendarCalendar   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   LinksLinks
 RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in  Chat RoomChat Room 
go to the radio page Live at electro-music.com radio 1 Please visit the chat
  host / artist show at your time
today> Modulator ESP Adventures In Sound

 Forum index » DIY Hardware and Software » Ken Stone designs - CGS
cynare caps question
Post new topic   Reply to topic Moderators: Scott Stites
Page 1 of 1 [3 Posts]		 View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
Author Message
rosch



Joined: Oct 03, 2009
Posts: 164
Location: germany
PostPosted: Thu Oct 29, 2009 5:29 pm    Post subject: cynare caps question Reply with quote  Mark this post and the followings unread
hi! i hope the question isn't too stupid: i'm soldering my cynare board but haven't been able to figure out from the schematics where the one 100nF 50V Polyester cap goes (the red guy) in order to not mistake it with one of the 8 pieces of 100nF decoupling caps (the small blue ones).
thanks in advance for any help!
Back to top
View user's profile Send private message
andrewF



Joined: Dec 29, 2006
Posts: 1176
Location: australia
Audio files: 4
PostPosted: Thu Oct 29, 2009 6:00 pm    Post subject: Reply with quote  Mark this post and the followings unread
hi
all questions are good

The only 100n I can see on the schematic connects to pad N for the shimmer pot. Look at the PCB, in the bottom left corner is the 4030/4070 IC, the 100n you want is the 4th component to the left from the 4030/4070.
it sits between a 100k resistor and a 100n decoupling cap.

enjoy!
Back to top
View user's profile Send private message Visit poster's website
rosch



Joined: Oct 03, 2009
Posts: 164
Location: germany
PostPosted: Fri Oct 30, 2009 10:40 am    Post subject: Reply with quote  Mark this post and the followings unread
thank you very much andrewF!
now it's just figuring out the correct pinout of the transistors and finishing my power supply!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic Moderators: Scott Stites
Page 1 of 1 [3 Posts]		 View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
 Forum index » DIY Hardware and Software » Ken Stone designs - CGS
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Forum with support of Syndicator RSS
Powered by phpBB © 2001, 2005 phpBB Group
Copyright © 2003 through 2009 by electro-music.com - Conditions Of Use