Wavefolder DC Output

[freiburg]

Hello everybody

I am not sure whether my wavefolder operates properly:

Range Pot on minimum (ground), sine wave at input. Control Voltage on ground. The output produces a DC ranging from -2V up to +0.5V depending on the position of the shape pot.

Beside of that the module does wavefolding, although in my opinion the sweet spot of the shape pot is somewhat small.

so i am not sure whether this device operates properly or not. any advices and comments are welcome.

christian

[Sebo]

Seem like your CV is leaking into the VCA.
Do you calibrated the VCA?

[freiburg]

yes calibration of the vca worked without problems and is very accurate.

so you say, some dc output is in fact a malfunction?

[yusynth]

Did you match the trannies of the VCA ?

[freiburg]

yes within 2mV