Sley Limmiter Voltage out

[gabrielcichero]

I build the yusynth Slew Limiter, works lovely!

I always care of tunings on my modular instrument, so i found some voltage differences at the output, that make my VCO connected to the Slew Limiter sounding a little out of tune (few milllivolts) when i switch betweewn LOG and LIN modes.

I send 1000mv to the Slew Limiter, it's output voltage is

-In LIN MODE: i read 997mv
-In LOG MODE: i read 1002

I read this post, which improved a lot the voltage drop:
http://electro-music.com/forum/post-269614.html

But it not resolved the voltages differences that i found switching between MODs.

Any idea in how to fix this?

---

1.jpg
Description:
Filesize:	197.78 KB
Viewed:	174 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

[gabbagabi]

i could imagine that this would work, but no garantie as always

what are u measuring if u put in a negative Volage?
the same but with negative sign?
if (so) printf "good";
else printf "u have to split up the two ways"

the fine pot is for being able to adjust the log- voltage to exact 1000mV,
later adjust the lin-voltage

---

cole slew.png
Description:
Filesize:	234.1 KB
Viewed:	166 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---