MOTM Blacet Time Machine

[PrimateSynthesis]

Blacet Time Machine in MOTM format

Built on a billet Stooge Industries panel from a Frac Rack PCB and board parts from a Blacet kit, with Bourns sealed conductive-plastic steel-shafts pots, genuine Alco knobs, and Switchcraft jacks.

Functions 100% as designed with the following mods:

Alias knob to control the amount input aliasing, provides original unmodified function at lowest setting. This unit does not have a Bypass switch, but the Bypass jack still functions as a VCA on the wet signal.

Ext/Mod uses switched TRS jack to provide envelope follower output and a third modulation input at the same time, requires use of insert cable, will replace with regular switched jack on request.


Includes Assembly and Users Manual, custom power cable, and a spare LM13600.


$600 plus shipping from U.S.

---

TM_panel.jpg
Description:
Filesize:	211.8 KB
Viewed:	238 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

TM_protection.jpg
Description:
Filesize:	354.27 KB
Viewed:	237 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

TM_alias.jpg
Description:
Filesize:	275.89 KB
Viewed:	231 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

TM_extmod.jpg
Description:
Filesize:	296.32 KB
Viewed:	241 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

---

TM_knobs.jpg
Description:
Filesize:	553.37 KB
Viewed:	233 Time(s)
This image has been reduced to fit the page. Click on it to enlarge.

---

[PrimateSynthesis]

I just went and edited the description to include that his module uses the Frac Rack PCB, not the 5U PCB. So the assembled board would fit behind a Frac Rack panel if someone really wanted it in Blacet format.

[PrimateSynthesis]

Price dropped.