electro-music.com   Dedicated to experimental electro-acoustic
and electronic music
 
    Front Page  |  Articles  |  Radio
 |  Media  |  Forum  |  Wiki  |  Links  |  Store
Forum with support of Syndicator RSS
 FAQFAQ   CalendarCalendar   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   LinksLinks
 RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in  Chat RoomChat Room 
Live streaming at radio.electro-music.com

  host / artist show at your time

poster

Please visit the chat
 Forum index » How-tos » Manuals, Instructions, and Documents
Hacking Behringer 802 Aux Sends
Post new topic   Reply to topic
Page 1 of 1 [2 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
Author Message
squarewhite



Joined: Jun 06, 2007
Posts: 82
Location: Asia

PostPosted: Tue May 22, 2018 8:44 am    Post subject: Hacking Behringer 802 Aux Sends Reply with quote  Mark this post and the followings unread

hi,

I just got the Behringer Xenyx 802 mixer and test it with my setup and it works wonderfully together. One thing I fail to notice is that the Aux send is post fader. Does anyone know of any hack to change the aux send from post fader to pre fader? I was looking for schematics on the mixer, but found none.

Any ideas?
Back to top
View user's profile Send private message
squarewhite



Joined: Jun 06, 2007
Posts: 82
Location: Asia

PostPosted: Tue May 22, 2018 9:30 am    Post subject: Reply with quote  Mark this post and the followings unread

ok I've found a schematic for the mixer. It's not exactly the Xenyx 802 but it's an older version, the UB 802. It seems that the Aux Send is after the EQs and jsut before the pan. I've circled that in red. And I 'think' that to make it pre-fader, I should cut the link before Resistor R127A and connect a cable after the broken link and before the 5k1 resistor to after C19. The links are marked in blue circles. Is this the place I could connect them? But there's a resistor R52 going to GND. Is that a pull down resistor?

I'm just figuring this out along with the schematics and tracing the connections and to the best of my knowledge. I won't want to blow this mixer up, so any professional advice is greatly appreciated.


BEHRINGER+UB802 excerpt.pdf
 Description:

Download
 Filename:  BEHRINGER+UB802 excerpt.pdf
 Filesize:  91.99 KB
 Downloaded:  22 Time(s)

Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic
Page 1 of 1 [2 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
 Forum index » How-tos » Manuals, Instructions, and Documents
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
e-m mkii

Please support our site. If you click through and buy from
our affiliate partners, we earn a small commission.


Forum with support of Syndicator RSS
Powered by phpBB © 2001, 2005 phpBB Group
Copyright © 2003 through 2009 by electro-music.com - Conditions Of Use