electro-music.com   Dedicated to experimental electro-acoustic
and electronic music
 
    Front Page  |  Articles  |  Radio
 |  Media  |  Forum  |  Wiki  |  Links  |  Store
Forum with support of Syndicator RSS
 FAQFAQ   CalendarCalendar   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   LinksLinks
 RegisterRegister   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in  Chat RoomChat Room 
 Forum index » DIY Hardware and Software » Circuit Bending
Hing Hon EK-001
Post new topic   Reply to topic Moderators: dnny, v-un-v
Page 3 of 3 [52 Posts]
View unread posts
View new posts in the last week
Mark the topic unread :: View previous topic :: View next topic
Goto page: Previous 1, 2, 3
Author Message
mworf



Joined: May 07, 2019
Posts: 1
Location: berlin

PostPosted: Tue May 07, 2019 1:51 am    Post subject: Reply with quote  Mark this post and the followings unread

dear hing hon ek-001 people,
I need your help. I already set a new on/off switch, pot for the volume and a kind of pitch-control pot. but unfortunately one of my speaker-cable disconnected and I can't find the right spot on the board.

I've got the single-board version. One speaker-cable is still on it's old place (same stripe as headphone-jack on the board).

maybe u can help me (with a picture or drawing Smile )
thank u!
Back to top
View user's profile Send private message
PHOBoS



Joined: Jan 14, 2010
Posts: 4440
Location: Moon Base
Audio files: 625

PostPosted: Wed May 08, 2019 2:34 pm    Post subject: Reply with quote  Mark this post and the followings unread

if it's the same board I used then one connection should go to GND and the other one to capacitor C12.
_________________
"My perf, it's full of holes!"
http://phobos.000space.com/
SoundCloud BandCamp MixCloud Stickney Synthyards Captain Collider
Back to top
View user's profile Send private message Visit poster's website AIM Address Yahoo Messenger MSN Messenger
Display posts from previous:   
Post new topic   Reply to topic Moderators: dnny, v-un-v
Page 3 of 3 [52 Posts]
View unread posts
View new posts in the last week
Goto page: Previous 1, 2, 3
Mark the topic unread :: View previous topic :: View next topic
 Forum index » DIY Hardware and Software » Circuit Bending
Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum
e-m mkii

Please support our site. If you click through and buy from
our affiliate partners, we earn a small commission.


Forum with support of Syndicator RSS
Powered by phpBB © 2001, 2005 phpBB Group
Copyright © 2003 through 2009 by electro-music.com - Conditions Of Use