From wiki

Schematics: Vactrol Panner

DIY | VCA | Panner | Vactrol | diablojoy

Vactrol Panner by diablojoy as shared on this thread with more details on the design as well as demo .From the comments there :

something i have been playing with this last week vactrol type isnt fussy i am using NSL32 but could just as well be vtl5c3, A slow closing vactrol like a vtl5c4 could be interesting also the P2 connector goes to a B100k pot pin 2 is the wiper just reverse 1 and 3 if left / right is wrong way round . note with the pot in the centre and no cv input there is no output.or at least very little CV input can be from an LFO output +5 to -5 volts though going to the rails will not hurt anything. T1 and T2 adjust the sensitivity for the vactrols you can get them pretty good just by watching the panel leds PD-L / PD-R while adjusting P2 for the supplied voltage though the actual vactrol response is slightly different to normal leds so also use your ears anyway hope someone can use this

Retrieved from
Page last modified on 2013-02-24 17:02 [UTC-7]