Help with basic mix setup

[nvisibl]

Hi, just purchased the A6 yesterday and i'm trying to setup a Mix to sequence 3 individual midi channels in Cubase SX3.

I've sat with the manual all evening, and read through the relevant sections of the tips n tricks website but I still cannot get things happening properly and would really appreciate some pointers.

Midi rx and tx is enabled
Localmid enabled
Mix channel 1 = Midi channel 1
Mix Channel 2 = Midi channel 2
Mix channel 3 = midi channel 3
all other mix channels disabled

The problem I have is that it seems to be playing in Omni mode with all 3 mix parts playing at the same time when a key is pressed and no matter what Midi channel is selected in Cubase.

There doesn't seem to be an Omni mode on/off setting?

Please help a noob out

Thanks a lot

[nvisibl]

Gotit eventually... silly oversight... worked fine when I changed localmid to just Midi

This forum is quite quiet eh?

[ten]

There dont seem to be that many Andy owners.....or not ones who use forums anyway

ten

[nvisibl]

yea strange man, i've noticed that theres not much noise on the web about them at all.

[ten]

To be honest, I prefer it like that actually...

Everywhere you look its TI this TI that, ooo I need a virus, virus soundset blah etc etc....totally saturated. Its nice having something slightly rare or elusive, especially something sounding as awesome as the Andy.

ten

[nvisibl]

aye.. yer right.. though even a reasonably active forum is priceless when your getting to grips with a new bit of kit, especially in something like the A6. but hey ho.... and a bottle of rum

[jonkull]